I am about to set up a 5.1 or 7.1 system. It will be on the second floor of a log home. It has a cathedral ceiling and the second floor is a 3/4 floor with 1/4 open for effect. Thus the room is a 30' x 15' one way and a 30x 15 the other. The speakers are going to be next to the TV towards the inner corner. Unavoidably, the right speaker will be about 3 feet from the back and 3 feet from one side wall, and the left speaker will be be 3 feet from the back wall and 17 feet from the left wall. The back speakers will be similar with about 17 feet in back of them. Basically I'll have a long wall to my right and lots of space (17') to my left wall. So, can this work or should I sell the system and get into model trains instead?
Speaker placement or Lionel trains?
- Thread starter bikerabbi
- Start date
Help Support MartinLogan Audio Owners Forum:
Hocky
Well-known member
My room is set up fairly similar to that - you can make it work. I actually used a wooden room partitioner decoration on the long side of the room to help it act a little bit more like the other wall. It is not perfect, but it works. Even bass response is the hardest part - 2 subs would help a lot.
2 subs are out of the budget since I just bought the ML things. Maybe I should build a 1/2 or 3/4 wall. Thanks.
Trains.......did you say trains ???
sell the system.....nothing beats the sound of 'live steam' !!
Attachments
Too cool!!! OK!
Sambob2
Well-known member
How much ya bet that box car is loaded with CLX's...
Uh, I hate to hijack this thread back to the original question but...
Will a set-up in an irregular sized room work or do the walls need to be equally spaced to do the the job. Can the output to one side be increased to make up for the open space? And - is my Yamaha RX-V2500 up to the task?Sambob2
Well-known member
Uh, I hate to hijack this thread back to the original question but...
In order to reproduce equal acoustic output from each driver, symmetry is always preferred...that includes not only dimensional symmetry but also acoustic symmetry. The material that the speaker sees as the first reflection should be the same on both sides or walls - and usually we want to create some absorption at that first reflection anyway. However when those times arise where you cannot accommodate symmetry, there is not much you can do to get the reproduction like you could if the room was symmetrical to begin with.
Sure you can increase the output from one speaker to accommodate the loss or greater distance from one wall over another, but it is not going to obtain the same results. In fact you will most likely distort the balance and imaging. In a non-symmetrical setup, you will be missing the interaction of the wall near the speaker. This will cause anomalies such as, uneven acoustic reflection, comb filtering or cancellation due to resonance, whether it be constructive or destructive interference and more.
Sometimes if you are far off of one wall with respect to the other channel(s), it may be best to install some sort of large (moveable) panel which duplicates the surface of the other side. If possible set your speaker which is closer to the inner corner of the room where you say the television is located. In other words don't push it out so far into the open area which makes up the inner "L" of the room.
If you have no choice but to locate the speaker out in the open area where the "L" is, then you may want to provide some absorption to the speaker which is on the opposite side of the room to the one closer against the long wall. The reason I say this is because the speaker out in the "L" (short wall) will not have as much reflection. I would not recommend increasing the level or changing the balance more to one channel over the other.
As far as your receiver, I don't know much about the Yamaha to comment on that. Impedance of Electrostatics can dip very low at certain frequencies and only the robustness of the Yamaha internals (hefty power supply, high current output stage, sufficient reserve and capacitance) will tell if it will do the job or not - particularly at higher volume levels.
Last edited:
hey Sam....your response, while detailed, would be presented much better if you puncuated it with a paragraph or two !
Sambob2
Well-known member
Point taken Dave, I'm guilty...
Bernard
Well-known member
bikerabbi, you don't say what speakers you are planning to drive with that Yamaha.
BTW, question on your handle: Are you a biker whose name is abbi, or are you a rabbi with a bike, or a rabbi biker ?
BTW, question on your handle: Are you a biker whose name is abbi, or are you a rabbi with a bike, or a rabbi biker ?
bernard, I'm guessing the vantages he mentions in his signature ?
BTW, question on your handle: Are you a biker whose name is abbi, or are you a rabbi with a bike, or a rabbi biker ?
LOL !! ....
.......better to be a Rabbi on a bike than rapper on one !
