Vantage issue. Clipping

[Rickschoppen]

Hi everyone. Anyone have an idea? My Martin Logan Vantage speakers have a problem. One of the speakers clicks as soon as it is turned on. (Not in stand-by )

I clean them every month and have done so now as well.
I have swapped everything: power, speaker cables, etc. But the clicking remains on one side. Only the panel itself is affected, the woofer has no issues.

Additionally, when I connect it to my amplifier, it clips. Even my DAC is flipping. . The other speaker has no issues at all.

I swapped the internal amp boards already to test that. Still the same.


Anyone have an idea?

 

[Jazzman53]

If, after swapping the power supply to the panel, the problem followed the panel, that would indicate a short somewhere in the panel, and the click would likely be an arcing event.

An area that can be prone to arcing is where the bias supply wire penetrates the panel edge, but arcing can occur anywhere on the panel, and can eventually burn thru the insulating powder coat on a stator, or even damage your amplifier if it progresses from diaphragm-to-stator arcing to stator-to-stator arcing.

An arc occuring out in middle/visible areas of the panel can sometimes be found by turning all the lights out to completely darken the room, and looking for a visible arc event (that would be the 'click' sound you are hearing). If you can localize it, it might be possible to repair it, but there's no point in talking about that until you find the arc site on the panel.