how do i hook up my crossover?

[rodman9866]

Hello everyone,

I have a pair of monolith III with the crossover. I want to just use my Krell KSA250 amp to push both the panel and the woofer. i will use my yamaha reciever as my preamp. anyone have this setup or know how to do this?

Thanks!

 

[jmschnur]

After you are done be sure to optimize the phase for ur subs and mains.

 

[JonFo]

Hello everyone,

I have a pair of monolith III with the crossover. I want to just use my Krell KSA250 amp to push both the panel and the woofer. i will use my yamaha reciever as my preamp. anyone have this setup or know how to do this?

Thanks!

I have Monoliths and have used passives, actives and everything in between on them.

Make sure you read the manual on the passive crossover and ensure your passive units are configured for single amp duty. That would allow you to run a single speaker cable from amp to crossover.

If unit is configured for bi-amping, and you don't want to fool with it, then you'd need to run two cables from amp to crossover (or use a local bridge cable).